64 Technology Way SE, Calgary
(403) 228-3421

Cad welding anodes on cast iron fittings

You must be logged in to view this content.

Start Course

Teacher

Difficulty
Easy

Installing water valve

You must be logged in to view this content.

Start Course

Teacher

Difficulty
Easy

San or storm SDR line

Steps you will see in the video: work with excavator operator to cut trench 4tinches below the invert of pipe for gravel bedding place gravel bedding to grade with laser clean the bell end of the pipe with a towel or rag lube the rubber and clear the end of the pipe to ensure no

Start Course

Teacher

Difficulty
Easy

Set up builders level

Steps you will see in the video: set the tripod up in a clear area away from equipment and midway from where you start and where you are going to finish the day off set tripod on flat surfaces and ensure the spikes are placed firmly in the ground and placed as level as possible

Start Course

Teacher

Difficulty
Easy

Setting up centerline

Steps you will see in the video: ask foreman for the offset of the centerline make sure the stake location you measuring from is the correct one (IE) the water, san and stm line measure what the offset is and place a paint mark on the ground and repeat this step at every survey station

Start Course

Teacher

Difficulty
Easy

Waterline install

Steps you will be seeing in the video: work with excavator operator to cut trench 4inches below invert of pipe for gravel bedding place gravel bedding to grade clean the bell end of the pipe with a towel or rag remove rubber in the bell and check for cracks or defects clean groove for rubber

Start Course

Teacher

Difficulty
Easy