Review drawings prior to pouring to confirm required finish, broom direction and tool mark locations Unload appropriate tools Spray the inside of the formwork with release oil When mixer shows up, ensure testing is completed if required Use mixer chute or line pump to fill formwork to level slightly above the top of forms Vibrate/bang […]
Steps you will be seeing in the video: work with excavator operator to cut trench 4inches below invert of pipe for gravel bedding place gravel bedding to grade clean the bell end of the pipe with a towel or rag remove rubber in the bell and check for cracks or defects clean groove for rubber […]
Steps you will see in the video: ask foreman for the offset of the centerline make sure the stake location you measuring from is the correct one (IE) the water, san and stm line measure what the offset is and place a paint mark on the ground and repeat this step at every survey station […]
Steps you will see in the video: work with excavator operator to cut trench 4tinches below the invert of pipe for gravel bedding place gravel bedding to grade with laser clean the bell end of the pipe with a towel or rag lube the rubber and clear the end of the pipe to ensure no […]
Steps you will see in the video: set the tripod up in a clear area away from equipment and midway from where you start and where you are going to finish the day off set tripod on flat surfaces and ensure the spikes are placed firmly in the ground and placed as level as possible […]
Set up lane/sidewalk closure as required, leaving enough room for the truck/trailer Ensure all cuts have been completed, including double cuts where required With smaller pieces, the double-cut may have to be broken with a sledgehammer and removed by hand Use the breaker to break all materials into a manageable size Remove all concrete/asphalt/gravel, dirt, […]
